6 x Crank pins for driving wheels
Set of 6 with retainers for 10BA tapped hole or for self-tapping into OUR wheels.NOTE: Extreme care must be taken if soldering the retainer onto the crank-pin as heat can damage the wheel centre.Inexperienced modellers should use Romford De-luxe crankpins with bushes and 14BA nuts.
Mashima 1220D Motor
L = 20mm. W = 12mm. D = 14mm. Fixing spacing holes 8mmOverall length 40mm - 1.5mm shaftNOW WITH 2 x M1.4 SCREWS
16mm /12-spoke driving wheel x 1
Produced by Scale Link/LSL with an ABS centre and nickled tyre.Designed for use with Romford axles. Released: JULY 2010.Diameter of drum is 16mm
Etched de-insulating pick-ups for Scale Link Driving Wheels
Specially designed for use with our driving wheels, these etched pick-ups can be fitted to all the sizes we produce.Fitting & Cutting instructions are included.Pack contains 2 pick-ups, usually sufficient for one locomotive.
Romford 16.5mm Axle (1/8" diameter)
MRAX/OO 1/8" diameter axle for 16.5mm track.Includes two brass fixing nuts.
Romford DeLuxe Crankpin sets (8)
Designed for use with motors with 8mm spacing between mounting screws.(Mashima 12xx series/Hanazono) 8.5mm wide - Romford 20-series gears.
25 x Standard crankpin fixing washers
Romford DeLuxe Outside Cranks x 2
Romford 16.5mm axle for OLDER Triang-Hornby chassis
This is 9/64th diameter axle for Triang/Hornby chassis with knurled gear-wheel grip for16.5mm track.Includes two brass fixing nuts