[sd.hide]-->
Product Sections
Main Pages
Best Sellers
Etched de-insulating pick-ups for Scale Link Driving Wheels
Specially designed for use with our driving wheels, these etched pick-ups can be fitted to all the sizes we produce.
Fitting & Cutting instructions are included.Pack contains 2 pick-ups, usually sufficient for one locomotive.18mm/16-spoke driving wheel x 1
Produced by Scale Link/LSL with an ABS centre and nickled tyre.
Designed for use with Romford axles. Released: JULY 2011Diameter of drum is 18mm.THEY'RE BACK!!!THESE WHEELS ARE SOLD SINGLYRomford Axle-nut screwdriver
Back in stock...
find out more
6 x Crank pins for driving wheels
Set of 6 with retainers for 10BA tapped hole or for self-tapping into OUR wheels.
NOTE: Extreme care must be taken if soldering the retainer onto the crank-pin as heat can damage the wheel centre.Inexperienced modellers should use Romford De-luxe crankpins with bushes and 14BA nuts.Markits DeLuxe Crankpin sets (6)
Back in stock
find out more
Romford 16.5mm Axle (1/8" diameter)
Markits 1/8th inch axle bush x 12
3.7mm OD x 2mm deep x 1/8th bore.
find out more
24mm/18-spoke Driving wheel x 1
Produced by Scale Link/LSL with an ABS centre and nickled tyre.
Designed for use with Romford axles. Released: JUNE 2013Diameter of drum is 24mm.THESE WHEELS ARE SOLD SINGLYMarkits flywheel 12mm diameter x 6mm x 1.5mm bore
Uses a Grub-screw to secure onto the motor shaft.
find out more
Markits DeLuxe Crankpin sets (8)